SICK, BEF Series Mounting Bracket 18.2 mm for Use with M18 Sensors
- N° de stock RS:
- 492-5032
- Référence fabricant:
- BEF-WN-M18
- Fabricant:
- SICK
Sous-total (1 unité)*
4,02 €
(TVA exclue)
4,86 €
(TVA incluse)
Frais de livraison offerts pour toute commande de plus de 75,00 €
En stock
- 51 unité(s) prête(s) à être expédiée(s)
- Plus 218 unité(s) prête(s) à être expédiée(s) d'un autre centre de distribution
Besoin de plus? Cliquez sur " Vérifier les dates de livraison " pour plus de détails
Unité | Prix par unité |
|---|---|
| 1 + | 4,02 € |
*Prix donné à titre indicatif
- N° de stock RS:
- 492-5032
- Référence fabricant:
- BEF-WN-M18
- Fabricant:
- SICK
Spécifications
Documentation technique
Législations et de normes
Détails du produit
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout | Attribut | Valeur |
|---|---|---|
| Marque | SICK | |
| Product Type | Thermocouple Connector | |
| Accessory Type | Mounting Bracket | |
| For Use With | M18 Sensors | |
| Series | BEF | |
| Hazardous Area Certification | No | |
| Width | 36.5 mm | |
| Height | 37mm | |
| Diameter | 18.2 mm | |
| Standards/Approvals | No | |
| Sélectionner tout | ||
|---|---|---|
Marque SICK | ||
Product Type Thermocouple Connector | ||
Accessory Type Mounting Bracket | ||
For Use With M18 Sensors | ||
Series BEF | ||
Hazardous Area Certification No | ||
Width 36.5 mm | ||
Height 37mm | ||
Diameter 18.2 mm | ||
Standards/Approvals No | ||
Statut RoHS : Exempté
L4000, Type 4 Single/Multibeam System
The L4000 is a single/multi beam, non contact, safety system using a sender and a receiver arrangement and is certified according to IEC 61496 safety category Type 4.,The system consists of the UE401 controller to which, sender and receivers can be connected. Up to 4 sensor pairs can be connected to the UE401
Applications:
This device is intended for body detection of an operator under normal approach conditions toward a hazardous area
Features:
Easy installation
7 segment display
Integrated alignment aid
Reset and External Device Monitoring
2 OSSD (Output Signal Switching Device) outputs
Short response time 30ms
IP67 sender and receiver
Single Beam Safety Device
Note
Installation and operation of this safety device must be in strict accordance with accompanying operating instruction. Further guidance on the use of Active Opto-electronic Protective Devices (AOPD) is available from Health & Safety Executive guidance note HSG180.
Liens connexes
- SICK, BEF Series Mounting Bracket for Use with SICK Dx35
- SICK, BEF Series Mounting Bracket for Use with SICK OD1000
- SICK, BEF Series Mounting Bracket for Use with SICK DT20
- SICK, BEF Series Mounting Bracket for Use with Sensors
- SICK, BEF Series Mounting Bracket for Use with G6
- SICK Mounting Bracket for Use with DX50
- SICK Mounting Bracket for Use with MH15V
- SICK, BEF Series Mounting Bracket for Use with M12 Sensors