Ultimaker Nozzle Nozzle for use with Ultimaker 2, Olsson Block 0.5 mm

Voir la catégorie

Sous-total (1 unité)*

48,12 €

(TVA exclue)

58,23 €

(TVA incluse)

Add to Basket
sélectionner ou taper la quantité
Dernier stock RS
  • 6 dernière(s) unité(s), prête(s) à l'envoi d'un autre centre de distribution
Unité
Prix par unité
1 +48,12 €

*Prix donné à titre indicatif

N° de stock RS:
110-1986
Référence fabricant:
OBS001
Fabricant:
Ultimaker
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout

Marque

Ultimaker

Product Type

Nozzle

Sub Type

Nozzle

Nozzle Material

Stainless Steel

For Use With

Ultimaker 2, Olsson Block

Nozzle Size

0.5 mm

Standards/Approvals

No

Statut RoHS : Exempté

Ultimaker 2 Jet Nozzle - Stainless Steel


The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With this special stainless steel nozzle, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean it efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer

If you print with abbrasive material like Carbon filled filament or Glowfill, this is the nozzle to have! Stainless steel is much stronger, it will wear down much slower than classic brass nozzles which can wear out during one long print! Only thing to remember is to print a little slower because of the difference in conductivity between stainless steel and brass

Ultimaker Accessories


Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Liens connexes