Ultimaker Nozzle Nozzle for use with Olsson Block, Ultimaker 2 0.25 mm

Voir la catégorie

Sous-total (1 unité)*

30,66 €

(TVA exclue)

37,10 €

(TVA incluse)

Add to Basket
sélectionner ou taper la quantité
Dernier stock RS
  • 43 dernière(s) unité(s), prête(s) à l'envoi d'un autre centre de distribution
Unité
Prix par unité
1 +30,66 €

*Prix donné à titre indicatif

N° de stock RS:
110-1982
Référence fabricant:
OBN001
Fabricant:
Ultimaker
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout

Marque

Ultimaker

Product Type

Nozzle

Sub Type

Nozzle

For Use With

Olsson Block, Ultimaker 2

Nozzle Material

Brass

Nozzle Size

0.25 mm

Standards/Approvals

No

Statut RoHS : Exempté

Pays d'origine :
NL

Ultimaker 2 Jet Nozzles


The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.

Use the 0.25mm brass nozzle to print small detailed prints, it's an expert nozzle (RS 110-1982)

The 0.4mm (RS 110-1983) is the standard size for a lot of 3D printers

If you print in wood filaments, this brass nozzle of 0.8mm is perfect for the job (RS 110-1985)

Ultimaker Accessories


Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Liens connexes