Ultimaker Nozzle for use with Ultimaker 2, Olsson Block 0.4 mm
- N° de stock RS:
- 110-1983
- Référence fabricant:
- OBN002
- Fabricant:
- Ultimaker
Actuellement indisponible
Nous ne savons pas si cet article sera de nouveau disponible. RS a l'intention de le retirer de son assortiment sous peu.
Produit de remplacement
Ce produit n'est pas disponible actuellement. Voici notre produit de remplacement:
la pièce
9,41 €
(TVA exclue)
11,39 €
(TVA incluse)
- N° de stock RS:
- 110-1983
- Référence fabricant:
- OBN002
- Fabricant:
- Ultimaker
Spécifications
Législations et de normes
Détails du produit
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout | Attribut | Valeur |
|---|---|---|
| Marque | Ultimaker | |
| Product Type | Nozzle | |
| Nozzle Material | Brass | |
| For Use With | Ultimaker 2, Olsson Block | |
| Nozzle Size | 0.4 mm | |
| Standards/Approvals | No | |
| Sélectionner tout | ||
|---|---|---|
Marque Ultimaker | ||
Product Type Nozzle | ||
Nozzle Material Brass | ||
For Use With Ultimaker 2, Olsson Block | ||
Nozzle Size 0.4 mm | ||
Standards/Approvals No | ||
Statut RoHS : Exempté
- Pays d'origine :
- NL
Ultimaker 3D Olsson Block Brass Jet Nozzle Printing Parts & Accessoriess
The Ultimaker allows for quick and easy nozzle changes, so different nozzle sizes can be selected to suit each project. Use a smaller nozzle to print fine lines for more detail, or use a larger nozzle to print thicker lines to decrease print duration. The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more.
Note:
This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.
Features and Benefits
Clean them efficiently with cold pulls
Print faster, the plastic flows much easier than in classic nozzles
The 0.4mm is the standard size for a lot of 3D printers
The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer
Use the 0.25mm brass nozzle to print small detailed prints
Liens connexes
- Ultimaker Nozzle Nozzle for use with Olsson Block, Ultimaker 2 0.25 mm
- Ultimaker Nozzle Nozzle for use with Ultimaker 2, Olsson Block 0.5 mm
- Ultimaker Nozzle Olsson Block Kit for use with Ultimaker 2
- Ultimaker Nozzle Nozzle for use with Olsson Block, Ultimaker 2 0.6 mm
- Ultimaker Nozzle for use with Olsson Block, Ultimaker 2+ 0.8mm
- Ultimaker Print Head for use with Ultimaker 2+ / Olsson Block 0.25 mm 0.6 mm, 0.8 mm
- Ultimaker Print Head for use with Ultimaker 2+ / Olsson Block 0.6 mm
- Ultimaker Nozzle for use with Ultimaker S3, Ultimaker S5 0.4 mm