STMicroelectronics Demonstration Board for ST1S12 for Powering Low-Voltage Digital Cores in HDD Applications

Voir la catégorie

Sous-total (1 unité)*

36,60 €

(TVA exclue)

44,29 €

(TVA incluse)

Add to Basket
sélectionner ou taper la quantité
Pénurie d'approvisionnement
  • Plus 3 unité(s) expédiée(s) à partir du 10 décembre 2025
Notre stock actuel est limité et nos fournisseurs s'attendent à des pénuries.
Unité
Prix par unité
1 +36,60 €

*Prix donné à titre indicatif

N° de stock RS:
196-1832
Référence fabricant:
STEVAL-ISA055V2
Fabricant:
STMicroelectronics
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout

Marque

STMicroelectronics

For Use With

Powering Low-Voltage Digital Cores in HDD Applications

Kit Classification

Evaluation Board

Featured Device

ST1S12

Kit Name

Demonstration Board

Pays d'origine :
IT
This demonstration board is based on the ST1S12 family of synchronous step-down DC-DC converters optimized for powering low-voltage digital cores in HDD (hard disk drive) applications, and is generally used to replace high-current linear solutions when power dissipation may cause high heating of the application environment. It provides up to 0.7 A over an input voltage range of 2.5 V to 5.5 V. A high switching frequency of 1.7 MHz allows the use of tiny surface-mount components. A resistor divider to set the output voltage value, an inductor, and two capacitors are required for the adjustable version, while only an inductor and 2 capacitors are needed for the 1.2 V and 1.8 V fixed version.

A low output ripple is guaranteed by the current mode PWM topology and by the use of low ESR surface-mount ceramic capacitors.

The ST1S12 device is thermal protected and current limited to prevent damage due to accidental short-circuit. This family of products is available in the TSOT23-5L package.

Liens connexes