onsemi NCP1618ADR2G, Power Factor Controller IC 65 kHz 9-Pin, SOIC 35 V
- N° de stock RS:
- 214-8827
- Référence fabricant:
- NCP1618ADR2G
- Fabricant:
- onsemi
Actuellement indisponible
Nous ne savons pas si cet article sera de nouveau disponible. RS a l'intention de le retirer de son assortiment sous peu.
- N° de stock RS:
- 214-8827
- Référence fabricant:
- NCP1618ADR2G
- Fabricant:
- onsemi
Spécifications
Documentation technique
Législations et de normes
Détails du produit
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout | Attribut | Valeur |
|---|---|---|
| Marque | onsemi | |
| Product Type | Power Factor Controller IC | |
| Start-up Supply Current | 1mA | |
| Sub Type | Power Factor Controller | |
| Maximum Source Current | 500mA | |
| Maximum Sink Current | 800mA | |
| Switching Frequency | 65kHz | |
| Supply Current | 1mA | |
| Zero Power Detection | Yes | |
| Mount Type | Surface | |
| Package Type | SOIC | |
| Minimum Supply Voltage | 9.5V | |
| Pin Count | 9 | |
| Maximum Supply Voltage | 35V | |
| Minimum Operating Temperature | -40°C | |
| Length | 5mm | |
| Series | NCP1618A | |
| Standards/Approvals | No | |
| Height | 1.75mm | |
| Width | 4 mm | |
| Maximum Operating Temperature | 125°C | |
| Automotive Standard | No | |
| Sélectionner tout | ||
|---|---|---|
Marque onsemi | ||
Product Type Power Factor Controller IC | ||
Start-up Supply Current 1mA | ||
Sub Type Power Factor Controller | ||
Maximum Source Current 500mA | ||
Maximum Sink Current 800mA | ||
Switching Frequency 65kHz | ||
Supply Current 1mA | ||
Zero Power Detection Yes | ||
Mount Type Surface | ||
Package Type SOIC | ||
Minimum Supply Voltage 9.5V | ||
Pin Count 9 | ||
Maximum Supply Voltage 35V | ||
Minimum Operating Temperature -40°C | ||
Length 5mm | ||
Series NCP1618A | ||
Standards/Approvals No | ||
Height 1.75mm | ||
Width 4 mm | ||
Maximum Operating Temperature 125°C | ||
Automotive Standard No | ||
The ON Semiconductor NCP1618 is an innovative multimode power factor controller. The circuit naturally transitions from one operation mode to another depending the switching period duration so that the efficiency is optimized over the line/load range.
Internal compensation of the Regulation loop
Line range detection