ROHM BD63621MUV-E2, Stepper Motor Driver IC 28-Pin, VQFN
- N° de stock RS:
- 235-2570
- Référence fabricant:
- BD63621MUV-E2
- Fabricant:
- ROHM
Actuellement indisponible
Nous ne savons pas si cet article sera de nouveau disponible. RS a l'intention de le retirer de son assortiment sous peu.
- N° de stock RS:
- 235-2570
- Référence fabricant:
- BD63621MUV-E2
- Fabricant:
- ROHM
Spécifications
Documentation technique
Législations et de normes
Détails du produit
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout | Attribut | Valeur |
|---|---|---|
| Marque | ROHM | |
| Product Type | Motor Driver IC | |
| Motor Type | Stepper | |
| Configuration | H Bridge | |
| Package Type | VQFN | |
| Pin Count | 28 | |
| Maximum Supply Voltage | 36V | |
| Sélectionner tout | ||
|---|---|---|
Marque ROHM | ||
Product Type Motor Driver IC | ||
Motor Type Stepper | ||
Configuration H Bridge | ||
Package Type VQFN | ||
Pin Count 28 | ||
Maximum Supply Voltage 36V | ||
The ROHM bipolar low-consumption driver that driven by PWM current. Rated power supply voltage of the device is 36V, and rated output current is 2.0A. CLK-IN driving mode is adopted for input interface, and excitation mode is corresponding to FULL STEP mode, HALF STEP mode, QUARTER STEP mode via a built-in DAC. In terms of current decay, the FAST DECAY/SLOW DECAY ratio may be set without any limitation, and all available modes may be controlled in the most appropriate way. In addition, the power supply may be driven by one single system, which simplifies the design.
PWM constant current
Built-in spike noise cancel function
Normal rotation & reverse rotation switching function
Power save function
Built-in logic input pull-down resistor
Power-on reset function
Thermal shutdown circuit
Adjacent pins short protection