GET Lighting Transformer, 230 → 240V ac, 11.4 → 11.6V ac
- N° de stock RS:
- 486-136
- Référence fabricant:
- GTRE200P
- Fabricant:
- GET
Indisponible
RS n'aura plus ce produit en stock.
Produit de remplacement
Ce produit n'est pas disponible actuellement. Voici notre produit de remplacement:
la pièce
70,68 €
(TVA exclue)
85,52 €
(TVA incluse)
- N° de stock RS:
- 486-136
- Référence fabricant:
- GTRE200P
- Fabricant:
- GET
Spécifications
Documentation technique
Législations et de normes
Détails du produit
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout | Attribut | Valeur |
|---|---|---|
| Marque | GET | |
| Primary Voltage Rating | 230 → 240V ac | |
| Secondary Voltage Rating | 11.4 → 11.6V ac | |
| Dimensions | 206 x 56 x 44 mm | |
| Length | 206 mm | |
| Width | 56 mm | |
| Depth | 44 mm | |
| Minimum Load Requirement | 70W | |
| Weight | 300 g | |
| Type | Electronic | |
| Dimming | Dimming | |
| Dimming Method | Trailing Edge | |
| Primary Current Rating | 17.4 | |
| Maximum Operating Frequency | 50Hz | |
| Sélectionner tout | ||
|---|---|---|
Marque GET | ||
Primary Voltage Rating 230 → 240V ac | ||
Secondary Voltage Rating 11.4 → 11.6V ac | ||
Dimensions 206 x 56 x 44 mm | ||
Length 206 mm | ||
Width 56 mm | ||
Depth 44 mm | ||
Minimum Load Requirement 70W | ||
Weight 300 g | ||
Type Electronic | ||
Dimming Dimming | ||
Dimming Method Trailing Edge | ||
Primary Current Rating 17.4 | ||
Maximum Operating Frequency 50Hz | ||
- Pays d'origine :
- CN
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Liens connexes
- Osram 50 → 225W Light Transformer 11.3V ac
- Osram 1 35 → 105W Light Transformer 11.3V ac
- Osram 1 20 → 70W Light Transformer 11.3V ac
- RS PRO 10 → 60W Light Transformer 11.5V
- Lighting Transformers
- Serious Lighting Transformer
- SolaHD 3kVA Chassis Mounting Transformer, 110 → 240V ac
- Sola 1500VA Chassis Mounting Transformer, 110 → 240V ac