Microchip Atmel-ICE Debugger, Development Kit for AVR Microcontrollers, SAM

Voir la catégorie

Sous-total (1 unité)*

76,49 €

(TVA exclue)

92,55 €

(TVA incluse)

Add to Basket
sélectionner ou taper la quantité
Commandes ci-dessous 75,00 € coût (TVA exclue) 5,95 €.
En stock
  • 7 unité(s) prête(s) à être expédiée(s)
  • Plus 12 unité(s) prête(s) à être expédiée(s) d'un autre centre de distribution
Besoin de plus? Cliquez sur " Vérifier les dates de livraison " pour plus de détails
Unité
Prix par unité
1 +76,49 €

*Prix donné à titre indicatif

N° de stock RS:
130-6124
Référence fabricant:
ATATMEL-ICE-PCBA
Fabricant:
Microchip
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout

Marque

Microchip

Product Type

Debugger

Sub Type

Development Kit

Kit Contents

In-Circuit Debugger/Programmer

For Use With

AVR Microcontrollers, SAM

Programmer Name

Atmel-ICE

Interface Type

TPI, 1 Wire, SPI, UPDI, JTAG, PDI, SWD

Standards/Approvals

No

ATATMEL-ICE PCBA


The Atmel-ICE series consists of development tools for debugging and programming ARM Cortex-M based Atmel SAM and Atmel AVR microcontrollers with on-chip debug capability. The Atmel-ICE series supports JTAG, SWD, PDI, TPI, aWire, SPI and debugWIRE interfaces and is compatible with Atmel Studio.

Kit Contains:


• Atmel-ICE unit without plastic encapsulation

130-6122 Full Kit available

130-6123 Basic Kit available

System Requirements


The Atmel-ICE unit requires that a front-end debugging environment Atmel Studio version 6.2 or later is installed on your computer. The Atmel-ICE should be connected to the host computer using the USB cable provided, or a certified Micro-USB cable.

How to turn the Atmel - ICE on?

The Atmel-ICE is powered by the USB bus voltage. It requires less than 100mA to operate, and can, therefore, be powered through a USB hub. The power LED will illuminate when the unit is plugged in. When not connected in an active programming or debugging session, the unit will enter low-power consumption mode to preserve your computer's battery. The Atmel-ICE cannot be powered down - it should be unplugged when not in use.

How does it connect?

The Atmel-ICE communicates primarily using a standard HID interface and does not require a special driver on the host computer. The Atmel-ICE must be connected to an available USB port on the host computer using the USB cable provided, or suitable USB certified micro cable. The Atmel-ICE contains a USB 2.0 compliant controller and can operate in both full-speed and high-speed modes. For best results, connect the Atmel-ICE directly to a USB 2.0 compliant high-speed hub on the host computer using the cable provided.

Kit Types:


Cable kit: 177-9591

Adapter kit: 177-9590

Basic kit: 130-6123

PCBA kit: 130-6124

Full kit: 130-6122

Liens connexes

Recently viewed