onsemi, USB Controller, 2-Channel 10 Gbps, 3.6 V, USB 3.1, 3.3 V, 30-Pin WQFN

Voir la catégorie
Actuellement indisponible
Nous ne savons pas si cet article sera de nouveau disponible. RS a l'intention de le retirer de son assortiment sous peu.
N° de stock RS:
195-2478
Référence fabricant:
NB7NPQ1002MMTTWG
Fabricant:
onsemi
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout

Marque

onsemi

Product Type

USB Controller

Number of Transceivers

2

Maximum Data Rate

10Gbps

Sub Type

Controller

USB Specification

USB 3.1

Power Supply Type

Single

ESD Protection

Yes

Maximum Supply Voltage

3.6V

Minimum Supply Voltage

3.3V

Mount Type

Surface

Package Type

WQFN

Pin Count

30

Supported Protocols

USB 3.1

Minimum Operating Temperature

-40°C

Maximum Operating Temperature

85°C

Length

4.6mm

Series

NB7NPQ1002M

Width

2.6 mm

Height

0.75mm

Standards/Approvals

No

Automotive Standard

No

The NB7NPQ1002M is a high performance single−Port linear redriver designed for USB 3.1 Gen 1 and USB 3.1 Gen 2 applications that supports both 5 Gbps and 10 Gbps data rates. Signal integrity degrades from PCB traces, transmission cables, and inter−symbol interference (ISI). The NB7NPQ1002M compensates for these losses by engaging varying levels of equalization at the input receiver, and flat gain amplification on the output transmitter. The NB7NPQ1002M offers programmable equalization and flat gain to optimize performance over various physical mediums. The NB7NPQ1002M contains an automatic receiver detect function which will determine whether the output is active. The receiver detection loop will be active if the corresponding channel’s signal detector is idle for a period of time. The channel will then move to Unplug Mode if a load is not detected, or it will return to Low Power Mode (Slumber mode) due to inactivity. Both the channels are independent with individual controls.

Liens connexes