Offre groupée disponible
Sous-total (1 unité)*
412,83 €
(TVA exclue)
499,52 €
(TVA incluse)
Frais de livraison offerts pour toute commande de plus de 75,00 €
En stock
- 1 unité(s) prête(s) à être expédiée(s) d'un autre centre de distribution
- Plus 10 unité(s) expédiée(s) à partir du 15 janvier 2026
Besoin de plus? Cliquez sur " Vérifier les dates de livraison " pour plus de détails
Unité | Prix par unité |
|---|---|
| 1 - 4 | 412,83 € |
| 5 + | 400,44 € |
*Prix donné à titre indicatif
- N° de stock RS:
- 239-6820
- Fabricant:
- RS PRO
Spécifications
Documentation technique
Législations et de normes
Détails du produit
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout | Attribut | Valeur |
|---|---|---|
| Marque | RS PRO | |
| Length | 75m | |
| Sélectionner tout | ||
|---|---|---|
Marque RS PRO | ||
Length 75m | ||
Statut RoHS non applicable
- Pays d'origine :
- GB
RS Rope Kits for All Rope Pull Switches
Supplied with all fittings and fixtures required to install any rope pull switch, including hazardous area versions
Stainless steel grade 316 and the cable is multi-strand galvanised steel covered with PVC
Two thimbles, collar clamps and "D" shackles are provided for securing each end of the grab wire to the safety switch
Stainless steel tensioner provided for switches that do not have this feature built in
Sufficient M6 eyebolts with locking nuts are provided to support the wire at approximately 2 to 3m intervals
First and last supports should be placed no more than 300mm from the end of the switch to ensure that the pull on the switch is linear
Vital for correct operation to ensure that the wire is free running when pulled
Rope may be cut to any suitable required length
Stainless steel grade 316 and the cable is multi-strand galvanised steel covered with PVC
Two thimbles, collar clamps and "D" shackles are provided for securing each end of the grab wire to the safety switch
Stainless steel tensioner provided for switches that do not have this feature built in
Sufficient M6 eyebolts with locking nuts are provided to support the wire at approximately 2 to 3m intervals
First and last supports should be placed no more than 300mm from the end of the switch to ensure that the pull on the switch is linear
Vital for correct operation to ensure that the wire is free running when pulled
Rope may be cut to any suitable required length
Liens connexes
- Bernstein AG SR Rope Pull Switch, 75m
- Bernstein AG SRM Rope Pull Switch, 75m
- Siemens 3SE7 Rope Pull Switch Straight
- Bernstein AG SRM Rope Pull Switch Straight
- SICK i150 Rope Pull Switch 2NC
- Banner RP-LS42F-xxL Rope Pull Switch 2NC Cable
- Pilz PSENrope Rope Pull Switch NO/NC, Straight
- Pilz PSENrope Rope Pull Switch 2NO/2NC, Side Mount