Eaton 1A T Glass Cartridge Fuse, 5 x 20mm

This range of glass cartridge fuses from Eaton Bussmann is ideal for providing protection to devices or internal circuits from short circuits and overcurrent. They are deliberately weaker components which, when too much current is drawn, will blow. Once the fuse has blown it will need replacing in order to make the circuit complete and allow the flow of current.

Why choose a glass cartridge fuse?

Glass and ceramic fuses have similar properties. However, you may choose a glass cartridge fuse as it enables you to see the inside of the fuse. Therefore it is easier to determine whether the fuse has blown.

What size is it?

5 mm x 20 mm is a standard cartridge size and it measures approximately 20 mm long by 5 mm in diameter. They are popular in board and panel protection and will fit a compatible 5 x 20 mm fuse holder.

What voltage is it?

These cartridge fuses are available with 40mA to 15 Amp current ratings for applications where the system voltage rating is 250 Volts AC.

What Speed is it?

This particular cartridge fuse is “T” speed rated which means it is a slow-acting fuse, sometimes referred to as anti-surge. It is able to tolerate higher levels for a short period, without shorting. Therefore, if a sudden change occurs, this fuse will not blow immediately. They are suitable for applications where a sudden flow of high current is required.

What is Breaking Capacity?

Breaking capacity is the level of current that the fuse can safely handle without exploding or rupturing. The breaking capacity of your fuse should be greater than the fault current of your electronic circuit. This particular cartridge fuse is LBC (Low Breaking Capacity).

What are cartridge fuses used for?

• For the protection of components and equipment from costly damage used by over-current
• To isolate sub-systems from the main system once a fault has appeared

When you need a fuse that can tolerate occasional power surges, turn to this glass cartridge fuse from Eaton . It has an F speed rating and low breaking capacity (LBC), so it won't blow when high voltages pass through it for a short period of time.
Use this unit in electronic devices and low-voltage industrial circuits that draw high power when starting up, such as small motors. The fuse body is made from transparent glass so it's easy to see when it needs replacing.

• Current rating of 1A and voltage rating of 250V AC is compatible with many automotive, telecommunications and engineering applications
• Standard cartridge size of 20mm (length) x 5mm (diameter) for use in a range of applications with compatible fuse holders
• Nickel-plated brass endcap construction for high corrosion resistance

Yes – the cartridge body is designed to clip easily into plug fuse holders without the need for tools and fixings. This fuse comes in a pack of 10, so you can keep spares to hand.

Eaton formerly known as Bussmann

UL, VDE, SEMKO, IMQ, MITI