Wappsto:bit Basic
- N° de stock RS:
- 225-1593
- Référence fabricant:
- SLX W11 001
- Fabricant:
- Seluxit A/S
Sous-total (1 unité)*
36,24 €
(TVA exclue)
43,85 €
(TVA incluse)
Frais de livraison offerts pour toute commande de plus de 75,00 €
Dernier stock RS
- 6 dernière(s) unité(s), prête(s) à l'envoi d'un autre centre de distribution
Unité | Prix par unité |
|---|---|
| 1 + | 36,24 € |
*Prix donné à titre indicatif
- N° de stock RS:
- 225-1593
- Référence fabricant:
- SLX W11 001
- Fabricant:
- Seluxit A/S
Spécifications
Documentation technique
Législations et de normes
Détails du produit
Recherchez des produits similaires en sélectionnant un ou plusieurs attributs.
Sélectionner tout | Attribut | Valeur |
|---|---|---|
| Marque | Seluxit A/S | |
| Product Name | Wappsto:bit Basic | |
| Sélectionner tout | ||
|---|---|---|
Marque Seluxit A/S | ||
Product Name Wappsto:bit Basic | ||
- Pays d'origine :
- DK
The Seluxit A/S Wappsto: bit brings the microcontroller to Wi-Fi and mobile network, displays sensor data on smart dashboards, and has optional GPS. The expansion board for the British learning microcontroller BBC Micro: Bit. The expansion takes place on different levels: on the one hand (and obvious at first glance) the wappsto:bit leads the GPIO connections of the Micro: Bit, which consist of bare contact surfaces of different widths, as normal pin strips with a grid dimension of 2, 54 mm out, as usual from Arduino, pico & Co. Practical: For each signal pin there is also one for 3.3V and one for GND - these connections often quickly become in short supply if you connect a lot of peripherals to a board.
3.3V sensors compatible with the BBC micro: bit
Edge-connector for micro: bit
ESP32-WROOM-32E, Wi-Fi and Bluetooth module with built in antenna
Micro USB power supply, operating voltage 4.5 to 5.5V
Button for resetting network settings
Edge-connector for micro: bit
ESP32-WROOM-32E, Wi-Fi and Bluetooth module with built in antenna
Micro USB power supply, operating voltage 4.5 to 5.5V
Button for resetting network settings