Ultimaker Nozzle for use with Olsson Block 0.4mm

  • N° de stock RS 110-1983
  • Référence fabricant OBN002
  • Fabricant Ultimaker
Documentation technique
Législations et de normes
Statut RoHS non applicable
Pays d'origine : NL
Détails du produit

Ultimaker 2 Jet Nozzles

The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.

Use the 0.25mm brass nozzle to print small detailed prints, it's an expert nozzle (RS 110-1982)
The 0.4mm (RS 110-1983) is the standard size for a lot of 3D printers
If you print in wood filaments, this brass nozzle of 0.8mm is perfect for the job (RS 110-1985)

Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Ultimaker 3D Olsson Block Brass Jet Nozzle Printing Parts & Accessoriess

The Ultimaker allows for quick and easy nozzle changes, so different nozzle sizes can be selected to suit each project. Use a smaller nozzle to print fine lines for more detail, or use a larger nozzle to print thicker lines to decrease print duration. The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more.
Note:
This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Features and Benefits

• Clean them efficiently with cold pulls
• Print faster, the plastic flows much easier than in classic nozzles
• The 0.4mm is the standard size for a lot of 3D printers
• The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer
• Use the 0.25mm brass nozzle to print small detailed prints

Ultimaker Accessories

Spécifications
Attribut Valeur
Product Type Nozzle
For Use With Olsson Block
Nozzle Material Brass
Nozzle Size 0.4mm
5 Livraison dès le lendemain
37 Sous 1 jours (stock Europe)
Prix Each
Ancien prix 31,20 €
26,00
(TVA exclue)
31,46
(TVA incluse)
Unité
Prix par unité
1 +
26,00 €